EN
7
2. INSTALLATION INSTRUCTIONS
Important!
The appliance must be installed by a qualified engineer in compliance with the
relevant regulations.
The washer-dryer is heavy. Take care when lifting it.
2.1 UNPACKING
The unit on flexible mounts is fixed in place for transport using the screws (A) on the
rear of the washer-dryer, with the relative plastic spacers (B). Once the screws have
been removed, the power supply lead can be used.
1. Undo all the screws with a 10 mm spanner
2. Remove all the screws (A) from the rear
3. Remove all the plastic spacers (B)
It is absolutely necessary to fit
supplied plastic plugs (C) in order to avoid splashes or
water penetrating the machine or to avoid contact with
live parts.
Warning!
Do not turn the appliance upside-down or place it on its sides.
All the transport retainer fittings should be kept in a safe place; they must be fitted
again if the appliance has to be moved around in the future.
A+B
A
B
C
To Next Page
Loading...
