Cleaning and maintenance
19
EN
8. For improved hygiene and to avoid food
being affected by any unpleasant
odours, we recommend that the oven is
dried using a fan-assisted function at
160°C for approximately 10 minutes.
4.10 Extraordinary maintenance
Replacing the internal light bulb
1. Completely remove all accessories from
inside the oven.
2. Remove the racks/trays support frames.
3. Remove the bulb cover using a tool (e.g.
a screwdriver).
4. Slide out and remove the lamp.
5. Replace the lamp with one of the same
type (40W).
6. Refit the cover correctly, so that the
moulded part of the glass is facing the
door.
7. Press the cover completely down so that
it attaches perfectly to the bulb support.
Removing the door seal
To permit thorough cleaning of the oven, the
door seal may be removed. There are
fasteners on all four sides to attach it to the
edge of the oven. Pull the 4 edges of the
seal outwards to detach the fasteners.
We recommend that you use
rubber gloves for these operations.
For easier manual cleaning of the
parts difficult to reach, we
recommend that you remove the
door.
Live parts
Danger of electrocution
• Ensure the appliance is switched off
before replacing the lamp to avoid the
possibility of electric shock.
Do not touch the halogen lamp
directly with your fingers, but wrap
it in an insulating material.
To Next Page
Loading...
