Cleaning and maintenance
24
Removing rack/tray support frames
Removing the guide frames enables the
sides to be cleaned more easily. This
operation should be performed each time
the automatic cleaning cycle is used (on
some models only).
To remove the guide frames: Pull the frame
towards the inside of the oven to unhook it
from its groove A, then slide it out of the
seats B at the back.
When cleaning is complete, repeat the
above procedures to put the guide frames
back in.
Cleaning the roof of the oven (on some
models only)
The appliance is fitted with a tilting heating
element which facilitates cleaning the top
part (roof) of the oven.
1. Pull the top heating element supports
gently towards you.
2. Gently lower the element until it stops.
3. When you have finished cleaning, push
the heating element back into position on
its supports.
Improper use
Risk of damage to the appliance
• Do not bend the heating element
excessively while cleaning.
To Next Page
Loading...
Need help?
General
