User instructions
9
run the soak program with partial loads.
The options cannot be used with the soak program.
The ENERSAVE option (if featured) cannot be used with soak, ultra clean, or any
programs which do not include the final drying stage.
* Standard program under
. The
option (if featured) must
See information sheet provided
(1) Program consumption and duration figures have been measured in accordance
with the EN 50242 standard. Values may vary depending on water supply and
and the type and quantity of dishes loaded.
1 or 2 cold rinses depending on the
REFERENCES for the ENERGY LABEL supplied with the dishwasher:
- Annual energy consumption is based on 280 standard wash cycles with cold
water using low-energy operating modes. Actual figures will depend on the
way in which the appliance is used.
- Water consumption is based on 280 standard wash cycles. Actual figures
will depend on the way in which the appliance is used.
- Information refers to the EN 50242 STANDARD program (identified in the
programs table), which is the most efficient in terms of combined energy and
water consumption. The program is recommended for dishes with a normal
level of dirt.
- Drying efficiency class on a scale from “G” (minimum efficiency) to “A”
(maximum efficiency).
To Next Page
Loading...
