5.5 CLEAN PROGRAMME
To keep the appliance operating at peak efficiency over time, it has a CLEAN programme for regular cleaning of
the drying circuit to remove any fluff deposits.
1. After a given number of drying cycles, the CLEAN symbol lights up on the display to warn that this pro-
gramme needs to be run. The warning light remains on until the CLEAN programme is carried out. The light
goes out at the end of the programme.
2. To perform the CLEAN programme, proceed as follows:
a. Make sure that the drum is completely empty and close the door.
b. Turn the knob to the CLEAN programme (see programmes table for the exact position on the knob)
c. Press the START/PAUSE button
The CLEAN programme can also be carried out even if the light on the display is not on.
CLEAN
programme
symbol
To Next Page
Loading...
