Safe Operating Recommendations
The typewriter is on electrical device with mechanical moving ports. To ovoid
unnecessary injury to the operator or damage to the machine , please review
the following recommendations .
20
1.
l3e sure that the correct electrical current is used. (Standard United States
and Canadian current is 110 to 120 volt, 60 Hz alternating current. )
Other countries may use different currents. If in doubt, check the electric
roting label affixed to the typewriter . The wrong kind of current could
cause on electrical short circuit and possible overheating or shocks.
2.
Do not, for any reason, cut or remove the grounding prong from the
power cord.
l3e sure it is plugged into a properly installed grounding
type receptacle . The three-prong grounding plug is provided for your
protection against shock hazards. Removing the prong or using on
improper receptacle eliminates that protection .
3. Always turn off the KEYDOARD switch before reaching into the area of
the ribbon cassette, correction tape, or printwheel.
4. Turn off the KEYDOARD switch and POWER switch when typing is com-
pleted .
5. Never insert metal objects such as screwdrivers, paper clips, nail files,
etc. inside a typewriter that is plugged in. An electrical shock may
result.
6. Always turn off the KEYDOARD and POWER switches before attempting
to retrieve items which may occidently drop into the typewriter .
7. If the typewriter is occidentally dropped, the jolt may disturb the insula-
tion system. Disconnect the cord from the outlet before picking up the
machine to ovoid possible shock. Hove the machine checked by a
qualified service technician before using it again .
8. Do not remove the covers from the typewriter. This should be done only
by qualified service technicians.
9. Always hove the typewriter serviced by a qualified service technician .
Always unplug machine before servicing.
10. When preparing the typewriter for travel or storage, always follow these
steps to distribute machine weight evenly and provide for a stable
package .
1 ) Turn off keyboard switch.
2) Wait for CARRIER to return to center position.
3) Turn off power switch.
4) Unplug the typewriter from the power supply.
5) Place typewriter in the case, close the lid, and be sure larches ore
secure.
11 . Never place the power cord, or any other object inside the machine,
particularly in the carrier path area .
1 2. Defore attempting to clean your machine with any recommended solutions,
make sure your machine is unplugged .
To Next Page
Loading...
