Storage Instruction
The presence of moister / water causes excessive corrosion, damage to the electronics and eventually the units to fail.
To prevent moisture / water ingress during storage observe the following guidelines:
• Keep units in a dry, protected place
• Avoid storing units outside (if outside is only choice, protect from elements)
• Make sure the conduit port on the back side of the housing is closed with the factory provided 3/4" NPT plug
• Use the factory provided Vapor Desiccant Pack (secured with double-sided adhesive tape) inside the housing
• Keep the covers mounted to the housing to protect the electronics
Note: If units are installed and are awaiting start-up / commissioning observe the following guidelines:
• Use conduit seal-off tting as per applicable electrical code
• Do Not leave units installed with open seal-off tting and / or removed covers where moisture can enter into
the UPT housing
TechnipFMC.com
© TechnipFMC 2017 MN01045 Issue/Rev. 0.7 (11/17)
TechnipFMC
FMC Technologies
Measurement Solutions, Inc.
500 North Sam Houston Parkway West,
Suite 100
Houston, Texas 77067 USA
P:+1 281.260.2190
USA Operation
1602 Wagner Avenue
Erie, Pennsylvania 16510 USA
P:+1 814.898.5000
Germany Operation
Smith Meter GmbH
Regentstrasse 1
25474 Ellerbek, Germany
P:+49 4101 304.0
Revisions included in MN01045 Issue/Rev. 0.7 (11/17):
Step 13 revised; Step 14 revised - tightening order diagram also added.
The specications contained herein are subject to change without notice and any user of said specications should verify from the manufacturer that the specications are currently in
effect. Otherwise, the manufacturer assumes no responsibility for the use of specications which may have been changed and are no longer in effect.
Contact information is subject to change. For the most current contact information, visit our website at www.fmctechnologies.com/measurementsolutions and click on the “Contact Us” link
in the left-hand column.
To Previous Page
Loading...