%'*
-);2<)-
!#$3## !
; 8&&D C J !+ - !+$> $ *++##$
)!###!
---Use the procedure below to align your tooling in the R-8
spindle:
'C'9/+"
'C 0 !+)! ) # $ !$ !+
9":!$!!+)-+!*!#*"
'C#1,-,,+#-1,!$*!$
$!9/+-*!$#"
5+)1,*!$-,+9#"!$8+!
,$$)!$"
-87-44C Use the procedure below for
attaching and securing the drawbar:
'C%*$)*
$!$-'B!$$L)*)!$"
' C # $- 1-! 9/+ # !
!$*!$#"&!!-!H
!$-##$-"
'C &! - , A+ $-" !-$-
9/+9*,!$"
'C%!-9/+L#!"
81-87-4C
Use the procedure below to remove tooling using the drawbar method:
'C'H$--!-$+!-
,)+1-!$-+"
'C6!$--+!+1-!"
'C&!$$-!!**!1$--$-
)$-!9/+)*!$"
&!-$-,-+!)!1#"&!-#
)+)!1#$-$*#$!$-
9/+"
'C3++#$-++!-!)*#"
'EC)!))*!$$9/+-,+)
$ +! / # )*$# ,+
*-1"
28