21
The vibration and noise emissions during actual use of the power tool can differ
from the declared value depending on the ways in which the tool is used
especially what kind of workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it is sharp and in good
condition.
The tightness of the grip on the handles and if any anti vibration and noise
accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately
managed.
To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level over the total working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and keep well lubricated
(where appropriate).
If the tool is to be used regularly then invest in anti vibration and noise
accessories. Plan your work schedule to spread any high vibration tool use
across a number of days.
Environmental protection
Waste electrical products must not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or
retailer for recycling advice.
To Next Page
Loading...