3
ALTUS - SureTrack User Setup
If you already have a SureTrack account, follow these
steps to setup and register your ALTUS account:
From a PC or mobile device:
1. Connect the thermal imager to a Wi-Fi network, see
Thermal Imager Elite Wi-Fi Connection on page 1.
2. Write down the Serial Number, PIN and Code that are
displayed when the device connects to the Wi-Fi network,
or leave the screen displayed. These codes can also be
found in the Settings menu, see ALTUS Setup Information
Screen on page 3.
3. Using a mobile device or PC, visit
https://ALTUSDRIVE.com and select Login (upper right
screen).
4. Log in using your SureTrack Username and Password.
5. Open Profile Manager (additional login may be required).
6. From the Device Management tab, select Add Device.
See Device Management on page 9 for a description of this
screen.
7. Enter your Serial Number, PIN, Code, and Device Name.
8. Log out of “Profile Manager”, then select the ALTUS Home
Page browser tab to get started.
9. Turn the thermal imager off, and then on.
10. See Using ALTUS for operation instructions.
Your thermal imager is now registered to your ALTUS online
account. When connected to Wi-Fi, your images will be
automatically sent to the online account from the device.
ALTUS Setup Information Screen
From the imager, selecting ALTUS Setup (Figure 4) from the
Settings menu allows you to view the diagnostic tool serial
number, PIN and Code needed to register on
ALTUSDRIVE.com.
1. Press the Menu button.
2. Select the Settings icon from the toolbar, then select
ALTUS Setup from the menu.
ALTUS Setup displays the following:
• Device Serial Number
• PIN
• Code
• ALTUSDRIVE.com QR code
This information is used when registering on
ALTUSDRIVE.com.
Figure 4
Note: The PIN and Code numbers will change each time you
view the ALTUS Setup screens (Figure 4 and Figure 5). This
is normal, any displayed set of PIN and Code numbers may
be used to register on ALTUSDRIVE.com.
Using ALTUS
Note: ALTUSDRIVE.com navigation and menu options will
vary by device and/or operating system (PC, mobile, etc).
Some menu selections may be grayed out or not shown,
indicating the option is not supported on your device/system.
Some menu options shown in these instructions may be not be
available on your device.
To use ALTUS
:
• An ALTUS account is required, see ALTUS Registration on
page 2.
• The thermal imager must be connected to a Wi-Fi network,
see Thermal Imager Elite Wi-Fi Connection on page 1.
Logging In to ALTUS
1. Using your mobile device or PC visit ALTUSDRIVE.com.
2. Select the Login icon (Figure 5).
Figure 5
i
Serial Number: 123HTM123456
PIN: 123456
Code: B12A456C
Go to ALTUSDRIVE.com
To Next Page
Loading...
Need help?
General