15
Toggle Backlight Setup
This function will allow user to enable or disable backlight toggle function. If toggle mode is disabled,
BACKLIGHT button turns on backlight and it automatically turns off after five seconds following any
last button press. If toggle mode is enabled, a BACKLIGHT button press will turn on backlight and
it will remain on until next BACKLIGHT button press.
1. From Settings menu, use UP /DOWN buttons to highlight TOGGLE BACKLGHT selection then
press ENTER button.
2. TOGGLE BACKLGHT screen is displayed.
3. Use UP /DOWN buttons to highlight ENABLE or DISABLE (factory default) selection.
4. Press ENTER button to accept selection and exit to Settings menu.
Note: Backlight will turn off when wrench powers down either by POWER button press or sleep
time.
Note: If toggle backlight is enabled and backlight is on, backlight will remain on during and after
applying torque.
Vibrator Configuration
This function will allow user to configure vibrator for On or Off when target is reached for preference
and/or battery power savings.
1. From Settings menu, use UP /DOWN buttons to highlight VIBRATOR CONFIG selection then
press ENTER button.
2. VIBRATOR CONFIG screen is displayed.
3. Use UP /DOWN buttons to toggle ON or OFF selection.
4. Press ENTER button to accept selection and exit to Settings menu.
To Next Page
Loading...
Need help?
General
