EEWH326A Tire Changer Operation Manual
- Page 14 -
1.6 GENERAL CAUTIONS
A. DURING THE USE AND MAINTENANCE OF THE MA-
CHINE IT IS MANDATORY TO COMPLY WITH ALL LAWS
AND REGULATIONS FOR ACCIDENT PREVENTION.
B. THE ELECTRICAL POWER SOURCE MUST HAVE A
GROUND CABLE AND THE GROUND CABLE OF THE
MACHINE MUST BE CONNECTED TO THE GROUND
CABLE OF THE POWER SOURCE.
C. BEFORE ANY MAINTENANCE OR REPAIRS ARE AC-
COMPLISHED THE MACHINE MUST BE DISCONNECTED
FROM THE AIR AND ELECTRICAL SUPPLY.
D. NEVER WEAR TIES, CHAINS OR OTHER LOOSE
ARTICLES WHEN USING, MAINTAINING OR REPAIR-
ING THE MACHINE. LONG HAIR IS ALSO DANGEROUS
AND SHOULD BE KEPT UNDER A HAT. THE USER MUST
WEAR PROPER SAFETY ATTIRE - GLOVES, SAFETY
SHOES AND GLASSES.
2.0 INSTALLATION
Your new Snap-on EEWH312A Series Tire Changer requires
a simple installation procedure requiring only a few moments.
Follow these instructions carefully to insure proper and safe
operation.
The Tire Changer is delivered mounted to a wooden skid.
Remove tire changer from its mounts carefully, taking care
to avoid any back strain.
Place Changer where proper operation will be unobstructed to
all sides. Install the machine in a covered and dry place.
2.0.1 Anchoring
Once placed in the desired location the tire changer must be
bolted to the fl oor using only the rear two mounting holes.
Mounting anchors are provided with those machines with a
Safety Restraint Arm.
Tire Changer should be anchored to concrete
fl oor for increased safety.
2.1 ELECTRICAL INSTALLATION
(air-electric models)
BUILDING ELECTRICAL INSTALLATION MUST BE
MADE BY A LICENSED ELECTRICIAN.
Check that the electrical specifi cations of the power source
are the same of the machine. The machine uses 110v, 60
hz, single phase 20 amp source. Electric specifi cations are
clearly marked on a label at the rear of the machine.
FAILURE TO PROVIDE PROPER ELECTRICAL SUP-
PLY AND GROUNDING WILL CREATE A SHOCK
HAZARD TO THE OPERATOR.
540
To Next Page
Loading...
