EEWH326A Tire Changer Operation Manual
- Page 16 -
3.0 CONTROLS
927
Figure 8
Before operating the machine, take the time to familiarize
yourself with the operation and function of all the controls.
A Press down and release the fi rst pedal (1) from the left:
the jaws of the turntable will retract. Do it again: the jaws
will expand. If you press the pedal prior to the end of
the stroke and release, the jaws may be stopped in any
position.
B Open the bead breaker arm. Press down and hold the
second pedal (2) from the left: by doing this you operate
the bead breaker blade and the arm will move towards
the machine. Release the pedal: the bead breaker blade
will retract.
WARNING!
WATCH YOUR FINGERS AND LEGS!
541a 542a
C Press down the fi rst pedal (3) from the right: the turntable
turns clockwise. Placing your foot under the pedal and
lift, the turntable turns counterclockwise.
D Lower the Lock Lever (4 ) to unlock the vertical slide, lift
the Lock Lever to lock.
E Turn Swing Arm Adjustment Knob (5) for positioning
mount/demount head slightly away from rim diameter
F Press bead-seater pedal on left side of the machine (6
) half way down: air will come out from infl ation hose
end.
G Press bead-seater pedal (6) all the way down swiftly to
get air blast from the infl ator jets in the clamping jaws.
Air simultaneously comes out of infl ator hose.
ATTENTION!
WHEN OPERATING THE BEAD SEATER IT IS MANDATO-
RY TO WEAR SAFETY GLASSES TO PROTECT EYES.
Standard Models ( IN, INA)
H Safety Restraint Arm (7) swings to center of the turn-
table.
I Lift upward on the restraint positioning knob (8) to posi-
tion over tire/wheel assembly for infl ation, at the same
time push down on the Anti-rotation Lock Arm to release
lock. (9) You may now swing the safety restraint arm to
position on the center of the wheel. Lower the restraint
until the rubber pad on the restraint disc is resting on
the rim center. The SRA is a gravity lock which will
automatically lock if any force other than the restraint
position knob is lifted. You are now ready for the infl ation
process.
NOTE: the air supply will not function until the safety
arm is centered over the turntable.
9
To Next Page
Loading...
