EEWH312A Tire Changer Operation Manual
- Page 25 -
7.0 MAINTENANCE
BEFORE STARTING ANY MAINTENANCE OPERATION
ENSURE THAT THE MACHINE IS DISCONNECTED FROM
THE AIR AND ELECTRIC SUPPLY.
A. Periodically clean the vertical hexagonal rod with non-
fl ammable liquid detergent.
After this immediately lubricate with a light lubricating oil
(Fig.27).
538
Fig.27
B. Periodically clean all moving metal parts and lubricate
with oil.
C. Weekly clean the teeth of the clamps (1) with a wire
brush, check the nylon clamping jaw insert and (2) replace
if worn (Fig.28).
346
Fig.28
D. Inspect and replace as necessary the plastic mount/
demount head insert. The insert is held in place by a small
roll pin. Drive the pin out with a punch, replace after new
insert is installed.
E. Lubricate piston rods of turntable air cylinders with oil as
needed.
F. Periodically wash all plastic parts with cold water and soap
or window cleaner.
G. Check the bead breaker pads. Replace if worn.
H. Discharge water from air fi lter every day.!! (Do this by
turning the knob “B” clockwise and upward. Water will au-
tomatically be discharged.) (see ‘B’ at Fig.29).
I. Check the automatic air lubricator oil level weekly. When
adding oil to the lubricator, disconnect the air supply fi rst,
remove the fi ll screw ‘A’, and add oil as needed. Make sure
seals are in place when replacing the cap.
553
Fig.29
NOTICE!
USE ONLY OILS FOR AIR DEVICES, DO NOT USE BRAKE
FLUID OR OTHER NON SUGGESTED LUBRICANTS.
Suggested oils for the fi lter/lubricator unit:
TAMOIL: WHITE MINERAL OIL 15
SHELL: ONDINA OIL 15
BP: ENERGOL WT 3
TOTAL: LOBELIA SB 15
ESSO: MARCOL 82
Water Separator Filter
Automatic Air Oiler
1
2
To Next Page
Loading...
