1. Position the battery pack (as shown)
with the arrows facing up. Tilt the top
of the battery in to align the tabs,
then down to install.
2. Install the battery pack cover, (in the
same manner as above) aligning
the tabs and screws.
3. Tighten the screws.
4. Press the Power button.
5. Select a function (e.g. Scanner, Tools,
or Oil Specs and Resets).
A
This side up.
Note - When you connect the data cable to a
vehicle’s data link connector (DLC), the
tool is powered by the vehicle.
6. Navigate menus and functions
using the touch screen, or the control
buttons.
Note - Do not overtighten screws.
Note - Use the battery indicator in the
upper right corner of the
Home screen to monitor the battery level.
Y - Accept selectionN - Cancel selection
Directional - Left/Right and Up/Down
GETTING STARTED
A
To Next Page
Loading...
