Snap-On POLARTEK EEAC330

To Next Page

To Previous Page

• 31 •

Press ENTER to continue:

Take the new filter

, wet with clean POE oil both o-rings, and

verify that they are correctly placed into their slots, press ENTER:

Insert the new dryer filter, use the special wrench (ref Fig. 19),

And press ENTER:

Press ENTER to continue with vacuum check:

If leaks are detected the following screen will be displayed:

Check filter tightening and press ENTER to restart the vacuum

check.

VACUUM LEAKS

Check filter tightening

and Press ENTER

R134a MAINTENANCE

CHANGE DRYER FILTER

Continue with vacuum and

check for leaks.

Press ENTER

R134a MAINTENANCE

CHANGE DRYER FILTER

Insert new dryer filter

use the special wrench

and press ENTER

R134a MAINTENANCE

CHANGE DRYER FILTER

Screw

DRYER

FILTER

Verify that both o-rings are correctly placed into their seats

press enter

R134a MAINTENANCE

CHANGE DRYER FILTER

Check leaks with vacuum

CHANGE DRYER FILTER

R134a MAINTENANCE

FIG. 19

FIG. 18

Snap-On POLARTEK EEAC330 - Page 31