109
10. How to use the red lock-o
11. How to install car seat rear-facing for Group 0+
(0-13kg, approx. birth to 1 year)
Open the red lock-o which is located at the side of the car seat, then insert
the vehicle shoulder belt into the red lock-o.
➀
➀
➁
➁
➂
➂
Open
Close
Step 1: Adjust the reclining
position of the car seat to level
4. Place the car seat facing the
vehicle seat backrest. Make
sure the front of the car seat is
resting firmly against the
vehicle seat backrest.
Step 2: Pull out the vehicle seat belt and
pass it through the seat belt route slot
at the back of the car seat.
Step 3: Pass the vehicle seat belt
through the other seat belt route slot
and fasten it into the buckle until you
hear a “click” sound.
Step 4: Pull and insert the vehicle
shoulder belt into the blue belt
hook ➀ and red lock-o ➁. Pass
the lap section of the vehicle belt
through the belt route slot for
Group 0+ ➂ .
click
To Next Page
Loading...