!
13
14
13. How to remove the car seat cover
Step 5: Place your child into the car seat and
secure him with the 5-point harness. Ensure the
harness is not twisted.
Note: Reclining position (level 1, 2, 3) is only
suitable for forward-facing installation. It can be
adjusted before or after installation.
Important: Do not use any load bearing contact points other than those
described in the instructions and marked on the child restraint.
Step 1: Press the red button on the
harness buckle to release the
5-point harness system.
Step 2: Turn the car seat to the
back, remove both shoulder belts
from the yoke connect plate.
Step 3: From the front of the car
seat, pull both shoulder belts out
from the shoulder belt route slots.
Step 4: Adjust the reclining position of
the car seat to level 4. Remove the buckle
metal plate from the crotch belt hole.
Step 5: The 5-point harness system, inner
cushion and other equipment can be removed
from the front of the car seat easily. Please
keep the equipment properly for future use.
Step 6: Take o the car seat
cover from the blue belt hook.
Step 7: Remove the car seat cover.
Notice: Do not remove the harness straps
from the car seat unless necessary.
To re-fit the car seat cover, please follow
the above method in the reverse order.
bottom view
To Next Page
Loading...
