Snapper 15 Series

N*
SECURE CHUTE DEFLECTOR
TO DECK WITH CARRIAGE BOLTS, /
FLAT WASHERS AND WING NUTS
-FIGURE 11
ELECTRICAL CIRCUIT
The electrical connection at the engine is shipped
disconnected to protect the electrical system when
the battery is installed and MUST BE THE LAST
STEP in preparation.
1. Connect electrical circuit at rear of the engine.
See Figure 12.
■ iSr
FIGURE 12
I. ENGINE
Perform engine service, oil and fuel, according to
engine manufacturer’s recommendations.
J. PRE-SALE CHECK
Completely fill out the attached Pre-Sale Checklist
BEFORE starting the engine, testing the Rear Engine
Rider or delivering to the customer.
The parts box contains the following:
gas tank, steering wheel, seat and hardware
bag. The particular gas tank, seat and hard¬
ware bag depends on the model rear engine
rider purchased. Replacement parts should
be ordered individually.