Snapper 21500 User Manual

INTRODUCTION
OPERATING PROCEDURE
This manual covers SNAPPER Series 0 walk behind
21" push and self-propelled mowers. Series 0 models
can (with the proper attachments) discharge chopped
and shredded mixed clipplings (MULCHING), bag
clippings (GRASS BAG), or vacuum thatch (THATCH-
ERIZER & GRASS BAG), or vacuum clippings and
leaves (SNAPPERIZER & GRASS BAG).
The THATCHERIZER is recommended for self-
propelled models. For more complete descriptions,
refer to the POPULAR ACCESSORIES section.
KNOW AND OBSERVE THE IMPORTANT SAFETY
INSTRUCTIONS WHEN OPERATING THE MOWER!
Know how to stop the mower in preparation for
possible emergencies BEFORE the first start-up!
For easier starting, move the mower to an area
where the blade can turn freely without being
restricted by tall grass.
The engine (and blade) is stopped by releasing the
BLADE CONTROL (7). On self-propelled models,
releasing the WHEEL DRIVE control (19) stops the
forward movement of the mower. Refer to FIG. 1 for
locations of controls.
WARNING: Never place your hands or feet near the
blade while the engine is running!
Always disconnect the spark plug wire before in-
specting/servicing the blade or mower!
\'' ./I
X
I
m 12 -
^ 6 -
L-
OPERATING/SERVICE POINTS
1 ADJUSTING LATCH (HEIGHT)
2 AIR BREATHER (COVER)
3 BAG
4 BAG ADAPTOR
5 BAG CONNECTOR
6 BAG WIRE SUPPORT
7 BLADE CONTROL
8 DECK
9 ENGINE
10 ENGINE CONTROL LEVER
11 FUEL FILLER CAP
12 GROUND SPEED CONTROL
FIG. 1-B
13 HUB CAP
MULCHING
14
LOWER HANDLE
DECK COVER DETAIL
15
OIL FILLER (DIPSTICK)
16
ROPE START HANDLE
l"\
18
UPPER HANDLE
19
WHEEL DRIVE CONTROL
20
KNOB
21
DECK COVER (RECYCLING)
FIG. 1-A - LOCATION OF
CONTROLS/FEATURES
FIG. 1-ROPE START
LOCATION OF CONTROLS/FEATURES

Snapper 21500 Specifications

General

Brand	Snapper
Model	21500
Category	Lawn Mower
Language	English