HANDLES & CONTROLS
Footnotes:
TP 400-5002-4-WB-N
Manual No. 700613621" STEEL DECK WALK BEHIND MOWERS
SERIES 17
5
Part No Descri
tionItem Qt
Note
1 7074254 1 HANDLE, Upper Was 72931 (used on Push
Models)
-- 7074254 1 HANDLE, Upper used on Self-Propelled
2 7036350 1 HANDLE, Middle- 1990 used on All
3 7046502 1 HANDLE, Lower Left Hand used on All
4 7035342 1 HANDLE, Lower Right Hand used on All
5 7047011 1 BAIL, Blade Control used on All
6 7033904 1 CLIP, Blade Control used on 2002 Models & Earlier
-- 7034872 1 CLIP, Blade Control used on 2003 Models & Later
7 7072933 1 CABLE, Blade Control (49-1/4” long) used on 2002 Models & Earlier
-- 7074868 1 CABLE, Blade Control (46-15/16” long) used on 2003 Models & Later
-- 7074830 1 CABLE, Blade Control (49” long) used on Honda 2003 Models &
Later
8 7032826 1 HANDLE, Wheel Drive used on Self-Propelled
9 7014307 1 GRIP, Wheel Drive Handle used on Self-Propelled
-- 7029775 1 GRIP, Wheel Drive Handle used on European Models
10 7072932 1 CABLE, Clutch Pull (Z-Bend, 38-5/8” long) used on Self-Propelled
11 7012121 1 COVER, Vinyl used on Self-Propelled
12 7012122 1 SPRING, Clutch used on Self-Propelled
13 7038478 1 SECTOR, Speed used on all other Self-Propelled
models
14 7024641 3 WIRE TIE, 1.29” Long (Black) used on Self-Propelled
15 7012093 1 SPRING, Speed Control used on Self-Propelled
16 7090188 1 WASHER, 3/8” Flat used on Self-Propelled
17 7023801 1 GRIP, Speed Control Handle used on all other Self-Propelled
models
18 7032830 1 ANCHOR, Speed Control used on all other Self-Propelled
models
19 7032408 1 GUIDE, Lower V-Belt used on Self-Propelled
20 7023790 1 ROD, Transfer used on Self-Propelled
20A 7051698 1 ASSEMBLY, Transfer Rod used on European Models
21 7010937 1 CLIP, Transfer Rod 1/4” used on Self-Propelled
22 7090895 1 TEE-NUT, 5/16-18 used on Self-Propelled
23 7012114 1 BUSHING, Differential used on Self-Propelled
24 7090595 1 BOLT, 5/16-18 x 3/4” Hex Flange Lock GR5 used on All
25 7090238 1 SCREW, 5/16-24 x 1” Hex Head Cap GR5 used on All
26 7090799 1 BOLT, 5/16-18 x 5/8” Short Neck Carriage GR5 Was 91026 (used on All)
27 7091601 10 NUT, 5/16-18 Hex Flange Lock GR5 Was 91070 (used on All)
28 7091606 1 NUT, 5/16-24 Hex Center Lock GR5 Was 91074 (used on All)
29 7023813 1 CLIP, Cable/Wiring used on All
30 7091740 4 SCREW, 5/16-18 x 1-7/8” Curved Head GR2 Was 91189 (used on All)
31 7035744 4 T-KNOB, 5/16-18 (BLACK) used on All
To Next Page
Loading...
Need help?
General
