Snapper 280915BE User Manual

DEALER PRE-SALE CHECKLIST
SET-UP CHECKLIST
_STEERING wheel and steering shaft assembled. Refer to Operator’s Manual or Service
_TIE RODS connected. Manual for Specific Torque Values not
_LUBRICATION of entire unit completed. Contained in this Checklist.
_OPERATOR’S SEAT installed and tightened.
_FUEL TANK installed and fuel line connected.
_GRASS DEFLECTOR, MULCH COVER or BAGGER BOOT & ASS’Y positioned, secured, checked.
_BATTERY activated and charged per battery instructions.
_BATTERY installed.
_TIRES inflated to proper psi. Front 15 psi, rear 10 psi.
CUTTING BLADE & DECK CHECKS
_BLADE RETAINING bolts at proper torque value. Torque from 35 to 55 ft. lbs.
_AIR LIFT bolts tight. Torque from 135 to 155 in. lbs.
_BLADE ALIGNMENT checked for equal tracking and adjusted as needed.
_BLADE STRAIGHTNESS checked and adjusted as required.
_DECK CUTTING HEIGHT SETTINGS checked and adjusted as needed.
_DECK SIDE-TO-SIDE LEVELNESS checked and adjusted as required.
_DECK FRONT-TO-REAR LEVELNESS checked and adjusted.
_BLADE LEVER checked and adjusted as required.
_BELT TENSION checked and adjusted as required.
PRE-START CHECKS & SERVICES
_ENGINE OIL - Refer to Engine Owner’s Manual for proper oil specifications.
_DIFFERENTIAL - Check lubricant and add as needed.
_CHAIN CASE - Check lubricant and add as needed.
_YOKE LIFT - Lubricate all pivot points and check for freedom of movement.
_FUEL - Add fuel to tank and check system for leaks. Refer to Engine Owner’s Manual for fuel specifications.
OPERATIONAL TEST
_INTERLOCK system checked for proper functioning.
_ENGINE started. Throttle control settings checked and adjusted as needed.
_IGNITION SWITCH checked to insure operation in all positions.
_PARKING BRAKE tested and adjusted as required.
_CLUTCH/BRAKE tested for proper operation and adjusted as required.
AUTOMATIC BLADE STOP TESTS
_BLADE stops no later than 3 seconds after blade pedal is released. Adjust blade brake as required.
_BLADE LEVER can be moved to “OFF” with BLADE PEDAL depressed.
DEMONSTRATION & INSTRUCTION
_PERSONALLY HANDED Operator’s Manual and Mower Safety Booklet to owner.
_INSTRUCTED owner to read and follow instructions in Operator’s Manual.
_DEMONSTRATED proper operation of unit to owner.
_AIR CLEANER SERVICE and ENGINE OIL CHECK procedure explained to owner.
_ASSISTED purchaser in completing Product Registration Card.
*per Operator’s Manual/Safety Instruction 28603
DEALER’S RECORDS
Sale Date_Model_Serial No._
Dealer’s Name,
Address_
. Signature,
. City,
State
ZiP_
MOWER WILL BE USED COMMERCIALLY? YES_ NO_
Purchaser’s Name_Signature_
Address_City_State,
.Zip,
IMPORTANT: This form is to be detached from booklet and retained by the Dealer for future
reference regarding Warranty, proof of purchase, traceability and product recall or service, etc.
!®McDonough, GA.,30253 U.S.A. INSTRUCTION No. 2-8604 (I.R. 5/95)
Printed in U.S.A.

Snapper 280915BE Specifications

General

Brand	Snapper
Model	280915BE
Category	Lawn Mower Accessories
Language	English