To Next PageTo Next Page
Need help?Do you have a question about the Snapper 7800632 and is the answer not in the manual?
General| Deck Material | Steel |
|---|---|
| Drive Type | Self-Propelled |
| Engine Displacement | 125cc |
| Drive System | Rear-Wheel Drive |
| Starting System | Recoil |
| Mulching Capability | Yes |
| Side Discharge | Yes |
| Bagging Capability | Yes |
| Cutting Positions | 6 |
| Oil Capacity | 20 oz |
| Side Discharge Capability | Yes |
| Cutting Width | 21 inches |
| Start Type | Recoil |
| Engine | Briggs & Stratton |
| Cutting Height | 1.25 - 3.75 in |
| Wheel Size | 8 in (front), 11 in (rear) |
| Fuel Tank Capacity | 0.5 gallons |
Remove the mower from its crate and skid. Ensure roll release rods are set to DRIVE.
Charge the battery and install it securely in the compartment, connecting cables properly.
Check blade installation and torque hardware to specified values (50-60 ft. lbs. / 68-81 N.m).
Verify engine oil level and adjust. Set tire pressures to 25 psi front, 15 psi rear.
Lubricate all grease and oil points as shown for proper operation and longevity.
Engage PTO for 15 seconds, repeat 10 times, checking blade stopping time (<= 5 seconds).
Perform any necessary adjustments as detailed in the Operator's Manual.
Verify safety interlock system and mower blade stopping mechanism function correctly.
