Troub leshooting
8
19
Problem Cause Remedy
Engine Fails to start 1. Blade control disengaged.
Spark plug boot disconnected.
3. Fuel tank empty or stale fuel.
4. Engine not primed (if equipped with primer).
Faulty spark plug.
6. Blocked fuel line.
7. Engine flooded.
8. Fuel valve (if equipped) closed.
9. Engine not choked (if equipped with choke).
10. Burnt fuse. (Electric Start only)
1. Engage blade control.
Connect wire to spark boot.
3. Fill tank with clean, fresh gasoline.
4. Prime engine as instructed in the Operation
section.
Clean, adjust gap, or replace.
6. Clean fuel line.
7. Wait a few minutes to restart, but do not
prime.
8. Open fuel valve. See engine manual.
9. Choke engine. See engine manual.
10. Replace fuse (see Service Section).
Engine runs erratic 1. Spark plug boot loose.
Blocked fuel line or stale fuel.
3. Vent in gas cap plugged.
4. Water or dirt in fuel system.
Dirty air cleaner.
6. Unit running with CHOKE (if equipped)
applied.
1. Connect and tighten spark plug boot.
Clean fuel line; fill tank with clean, fresh
gasoline.
3. Clear vent.
4. Drain fuel tank. Refill with fresh fuel.
Refer to engine manual.
6. Push CHOKE knob in.
Engine overheats 1. Engine oil level low.
Air flow restricted.
1. Fill crankcase with proper oil.
Clean area around and on top of engine.
Occasional skips
(hesitates) at
high speed
1. Spark plug gap too close. 1. Adjust gap to .030”.
Idles poorly 1. Spark plug fouled, faulty, or gap too wide.
Dirty air cleaner.
1. Reset gap to .030” or replace spark plug.
Refer to engine manual.
Excessive Vibration 1. Cutting blade loose or unbalanced.
Bent cutting blade.
1. Tighten blade and adapter. Balance blade.
See an authorized service dealer.
Continued on next page
To Next Page
Loading...
Need help?
General
