What to do if Snapper Lawn Mower blade(s) are not cutting?
If the blades on your Snapper Lawn Mower are not cutting, first ensure the blade control is in the ON position. If the mower belt is slipping, have it adjusted or replaced. If the cutting blade is dull, worn, or damaged, sharpen or replace it.
Why does my Snapper 7800932-00 engine lose power?
If your Snapper Lawn Mower engine loses power, start by cleaning or replacing the engine air pre-cleaner or air cleaner filters. Next, service the spark plug. Then, drain and clean the fuel system and replace the filter. Finally, clean all debris from the engine cooling screen.
How to fix Snapper 7800932-00 Lawn Mower cutting grass improperly?
If your Snapper Lawn Mower is cutting grass improperly, check and adjust the tire pressure as needed. Adjust the cutting height and move the engine speed control to the FAST position. Also, adjust the unit to a slower ground speed. Adjust the side to side leveling and the front to rear leveling. Sharpen the cutting edges or replace the blade(s). If the mower belt is slipping, adjust the tension or replace the mower belt.
Why does my Snapper Lawn Mower have poor grass discharge?
To resolve poor grass discharge with your Snapper Lawn Mower, move the engine speed control to the FAST position and adjust the unit to a slower ground speed. Ensure you mow when the grass is dry. Service the mower blade and clean the underside of the deck. Install proper blades on the deck.
Why does my Snapper Lawn Mower engine stall after running?
If your Snapper Lawn Mower engine stalls after running, ensure you are seated properly. If equipped, move the engine speed control to the FAST position, and check if the fuel tank is empty and fill it if needed. Clean the engine air pre-cleaner and air cleaner to remove any debris. Also, service the spark plug, replace the fuel filter if it's restricted, and drain and clean the fuel system to remove any water, debris, or stale fuel.
How to reduce excessive vibration in my Snapper Lawn Mower?
If your Snapper Lawn Mower is experiencing excessive vibration, service any damaged, out of balance, or bent mower blades. Service and tighten any loose blade components. Replace any loose or missing air lifts and tighten them to the proper torque. If there's a lumpy or frayed belt, replace it.
Why is my Snapper Lawn Mower leaking oil?
If your Snapper Lawn Mower is leaking oil, verify the chain case or differential plugs are not cracked and are in good shape. Check the gaskets.
General| Engine Displacement | 190cc |
|---|---|
| Cutting Width | 21 inches |
| Drive System | Rear-Wheel Drive |
| Oil Capacity | 20 oz |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge Capability | Yes |
| Cutting Height | 3.75 inches |
| Fuel Tank Capacity | 0.5 gallons |
| Wheel Size | 10 inches (rear) |
| Engine Type | Briggs & Stratton OHV |
To Next Page
