Snapper CP215519HV - HANDLES & CONTROLS - Upper End

HANDLES & CONTROLS - Upper End
Footnotes:
TP 400-5189-A-WB-N
Manual No. 700615521" STEEL DECK WALK BEHIND
SERIES 19 & 20
5
Part No Descri
p
tionItem Qt
y
Note
1 7074411 1 HANDLE, Upper
2 7074156 1 HANDLE, Middle
3 7074418 1 BAIL, OPC Control
4 7034872 1 CLIP, Zone Control
5 7074141 1 CABLE, Zone Control (56-5/16” Long) used on CP216019KWV &
CRP216019KWV
5 7029344 1 CABLE, Zone Control (49.98” Long) used on CP215519HV
5 7102235 1 CABLE, Zone Control (60.3” Long) used on CP215520HV
6 7074473 1 HANDLE, Clutch
7 7075305 1 COVER, Grip, Black 1.125” used on CP215519HV &
CP215520HV
7 7028407 1 GRIP, International Symbol, Black 4.6”
8 7034604 1 CABLE, Clutch Control (41-1/4” Long)
9 7012121 1 COVER, Vinyl
10 7012122 1 SPRING, Clutch- 21S
11 7074003 1 BRACKET, Shift
12 7074133 1 ROD, Speed Control (1/4-28 thread)
13 7091305 1 SCREW, 3/8-16 x 2” Hex Head Cap, GR 5
14 7031961 2 WASHER, 7/16” Flat
15 7028465 2 WASHER, Nylon
16 7091190 2 BOLT, 5/16-18 x 1-1/2” Curved Head
17 7091576 2 NUT, 1/4-20 Hex was 7091100
18 7023813 3 CLIP, Wiring Harness
19 7079577 2 SCREW, 1/4-20 x 1-1/2” Hex Head Cap GR5
20 7026219 1 CLAMP, 7/8” Double Cable
21 7090505 2 SCREW, 1/4-20 x 2” Hex Head Cap, GR 5
22 7090053 2 WASHER, 1/4” Internal Tooth Lock was 7091023
23 7074140 1 CONTROL PANEL (w/o Electrical Switch Hole)
24 7091200 4 SCREW, 1/4-20 x 1/2” Pan Head Self-Tap (Torx)
25 7014343 2 BUSHING, .27 x .35 x .4 Flange
26 7023792 1 PIN, 1/4 x 1-1/2”
27 7091020 1 PUSH-NUT, 1/4”
28 7023810 1 FOAM GRIP, 18.75” long
29 7090391 2 WASHER, 5/16” Internal Tooth Lock
30 7100181 1 DECAL, Commercial, Control Panel
31 7091069 2 NUT, 5/16-18 Hex, GR 5 or 7091511
32 7029782 1 DECAL, OPC Bail (International Symbol)
33 7028488 1 GUIDE, Rope (1/4-20 thread)
34 7028568 1 WASHER, Belleville
Not for
Reproduction