Snapper ERZT185440BVE, ERZT20441BVE2, RZT22500BVE2, RZT22501BVE2 - DECK GROUP (Sub-Assembly

50" DECK GROUP (Sub-Assembly)
Footnotes:
TP 400-5182-D-HZ-N
Manual No. 7006461RZT TWIN STICK HYDRO DRIVE 250 Z
SERIES 0 & 1
61
Part No Descri
p
tionItem Qt
y
Note
1 7400079 1 WELDMENT, 50” Mower Deck, SNAPPER
2 7500022 3 GROUP, 50” Spindle, RZT
3 7074467 3 * NUT, 3/4-16 Hex Jam, GR 8
4 7032027 6 * WASHER, .77 x 1.5 x .06 Flat case hardened steel
5 7014544 3 * PULLEY, 4-3/4” O.D.
6 7014407 2 * WASHER, Spindle (Special)
7 7012491 2 * RING, 1.85” Internal Retaining
8 7013313 2 * BEARING, Spindle
9 7200001 1 * SHAFT, Blade Spindle (6-11/16” overall length)
10 7400000 1 * WELDMENT, Spindle Housing
11 7010817 1 * LUBE FITTING, 3/16” Press-In
12 1708229 1 * BLADE, 18-1/8”
13 7016440 2 * WASHER, Beveled
14 7090658 1 * NUT, 5/8-18 Hex Jam
15 7091601 17 NUT, 5/16-18 Hex Flange Lock, GR 5
16 7091905 16 BOLT, 5/16-18 x 7/8” Hex Flange Lock, YZ
17 7091602 1 BOLT, 5/16-18 x 1-1/2” Hex Flange Lock, GR 5
18 7046780 13 PLUG, Hole (Polyethylene)
19 7091619 1 NUT, 3/8-16 Hex Flange Lock
20 7091541 5 SCREW, 5/16-18 x 3/4” Hex Washer Self-Tap
21 7091130 1 WASHER, .33 x .88 x .09 Flat
22 7091588 1 BOLT, 3/8-16 x 3/4” Hex Flange Lock, GR 5, YZ
23 7300137 1 IDLER PULLEY BRACKET, 44/50”
24 7092000 1 BOLT, 3/8-16 x 2-3/4” Round Head Square Neck, GR 5
25 7900009 2 BOLT, 3/8-16 x 2-1/4” Round Head Short Square Neck, GR 5
26 7100605 1 PAD, Rubber Adhesive
NOTE: * Quantity shown is per item 2 (7500022, Spindle Assembly).