10
Section 2 - OPERATING INSTRUCTIONS
2.3.5. CUTTING HEIGHT ADJUSTMENT
This machine has seven different cutting height
positions. IMPORTANT: When positioning the
cutting deck into a higher cutting position, pull up on
the deck lift handle only, it is not necessary to pull
up on the release lever at the same time. Use the
release lever when moving deck cutting height to a
lower cutting position.
1. Grasp both handles together to disengage
latch.
2. Raise or lower handles to desired height.
3. Release lower handle to engage latch. See
Figure 2.9.
FIGURE 2.9
DECK LIFT
HANDLE
DECK LIFT HANDLE SHOWN
IN HIGHEST NOTCH.
RELEASE
LEVER
DETENT
PLATE
CONNECTING BAR OMITTED IN THIS
VIEW FOR CLARITY
To Next Page
Loading...
