Snapper RT5 series - HANDLE DISASSEMBLY AND REASSEMBLY

FIGURE 5. 4 ■ HANDLE BRACKET DETAILS
HANDLE DISASSEMBLY PROCEDURE
STEP 1: Disassemble handle assembly. Note: Leave stud in place on handle.
STEP 2: Place handle on table \«ith stud and cap screw facing up.
STEP 3: Slide handle arm through handle bracket so that the notches face each other.
STEP 4: Place handle bracket and arm on stud.
STEP 5: Place handle brace over cap screw. Secure with (2) self-tapping screws. Place spring, flat washer,
and nut on cap screw.
5-2