Snapper SERIES 19 - Page 5

HANDLES & CONTROLS
Footnotes:
TP 400-5187-B-WB-N
Manual No. 700614921" STEEL DECK WALK BEHIND MOWERS
SERIES 19
5
Part No Descri
p
tionItem Qt
y
Note
1 7074411 1 HANDLE, Upper
2 7074156 1 HANDLE, Middle
3 7033985 1 HANDLE, Lower LH (Adjustable)
4 7033986 1 HANDLE, Lower RH (Adjustable)
5 7074418 1 BAIL, OPC Control
6 7034872 1 CLIP, Zone Control
7 7034608 1 * CABLE, Zone Control (52-63/64” Long)
7 7074141 1 * CABLE, Zone Control (56-5/16” Long)
7 7078078 1 * CABLE, Zone Control (50-31/64” Long)
7 7100976 1 * CABLE, Zone Control (53-47/64” Long)
8 7074473 1 HANDLE, Clutch
9 7028407 1 GRIP, International Symbol
10 7034604 1 CABLE, Clutch Control (41-1/4” Long)
11 7012121 1 COVER, Vinyl
12 7012122 1 SPRING, Clutch - 21S
13 7074003 1 BRACKET, Shift
14 7024641 2 TIE, Wire, 1.29 long, black
15 7073822 1 BRACKET, Bell Crank
16 7013849 1 SPACER, .33 x .63 x .156
17 7073913 1 BELL CRANK
18 7074140 1 CONTROL PANEL (w/o Electrical Switch Hole) Used on Manual Start Models
18 7074469 1 CONTROL PANEL (w/Electrical Switch Hole) Used on electric start models
18 7073826 1 CONTROL PANEL (w/o wheel drive slot) used on 2167519BFC &
2167519B
19 7091200 4 SCREW, 1/4-20 x 1/2” Pan Head Self-Tap (Torx)
20 7091130 2 WASHER, .33 x .88 x .09 Flat
21 7091904 1 SCREW, 5/16-18 x 7/8” Hex Head Cap, GR 5
22 7090895 1 TEENUT, 5/16-18 or 7090538
23 7012114 1 BUSHING, Differential, .328 x .625 x .41
24 7090595 2 BOLT, 5/16-18 x 3/4” Hex Flange Lock GR 5
25 7091070 2 NUT, 5/16-18 Hex Flange Lock, GR 5 or 7090585 or 7091601
26 7091067 1 NUT, 5/16-18 Hex Center Lock
27 7074113 1 LEVER, Shift
28 7091606 1 NUT, 5/16-24 Hex Center Lock GR 5 or 7091074
29 7023813 1 CLIP, Wiring Harness
30 7091189 4 SCREW, 5/16-18 x 1-7/8” Curved Head GR 2 or 7091740
31 7035744 4 KNOB, 5/16-18 Wing (Black)
31 720727 4 KNOB, 5/16-18 Wing (Black) Briggs part
NOTE: * Part number and revision is stamped on cable.