Snapper SERIES 19 - Page 7

HANDLES & CONTROLS
Footnotes:
TP 400-5187-B-WB-N
Manual No. 700614921" STEEL DECK WALK BEHIND MOWERS
SERIES 19
7
Part No Descri
p
tionItem Qt
y
Note
32 7079577 2 SCREW, 1/4-20 x 1-1/2” Hex Head Cap GR 5
33 7090053 5 WASHER, 1/4” Internal Tooth Lock or 7091023
34 7091100 3 NUT, 1/4-20 Hex or 7091576
35 7090505 1 SCREW, 1/4-20 x 2” Hex Head Cap, GR 5
36 7014343 2 BUSHING, .27 x .35 x .4 Flange
37 7023792 1 PIN, 1/4 x 1-1/2”
38 7091020 1 PUSH-NUT, 1/4”
39 7015753 2 BALL JOINT, 1/4-28
40 7090095 4 NUT, 1/4-28 Hex
41 7023810 1 FOAM GRIP, 18.75” long
42 7091305 1 SCREW, 3/8-16 x 2” Hex Head Cap, GR 5
43 7091585 1 NUT, 3/8-16 Hex Center Lock
44 7090391 4 WASHER, 5/16” Internal Tooth Lock
45 7031961 8 WASHER, 7/16” Flat
46 7028465 2 WASHER, Nylon
47 7074133 1 ROD, Speed Control (1/4-28 thread)
48 7028488 1 GUIDE, Rope (1/4-20 thread)
49 7076978 1 NUT, 1/4-28 Hex GR 5 or B
50 7012080 1 CABLE-TIE, 7”
51 7074460 1 THROTTLE CONTROL, (48.5”) used on Briggs models
51 7074138 1 THROTTLE CONTROL, 6.0 KWV (53.25”) used on Kawasaki models
51 7100975 1 THROTTLE CONTROL, RP, D.O.V. Engine (50.0”) used on Briggs DOV engines
52 7075308 1 THROTTLE KNOB (Red)
53 7075182 1 KNOB, Shift (Red)
54 7026219 1 CLAMP, 7/8” Double Cable
55 7091167 1 SCREW, #8-32 x 1/2” Cross Recess Filister Head Machine
56 7091018 1 NUT, #8-32 Hex
57 7091151 1 SCREW, 5/16-18 x 1-1/4” Hex Washer Head Self-Tap
58 7028568 1 WASHER, Belleville
59 7090238 1 SCREW, 5/16-24 x 1” Hex Head Cap GR 5
60 7090188 1 WASHER, 11/32” Flat
61 7034162 1 COTTER PIN, 5/16 Self Lock
62A 7100183 1 DECAL, Easy Speed, Control Panel
62B 7100182 1 DECAL, Snapper Control Panel used on Push models
63 7023153 1 CLAMP, Casing
64 7023154 1 SCREW, #10-32 x 5/8” Self-Tap
NOTE: * Part number and revision is stamped on cable.