Snapper Simplicity ZT3000

Simplicity / Snapper ZTR
8/2007 3
TP 300-7337-01-CH-SMN
Quick Setup List -
Page Setup Procedure Steps to Perform
4 Uncrating ❏ Remove crate & banding.
❏ Place transmissions in PUSH position & roll off skid.
4 Battery Activation & ❏ Charge the battery
Installation ❏ Test battery with hydrometer or load-tester.
❏ Install & secure battery.
5 Rider Assembly ❏ Install the seat and connect the seat switch
❏ Install ground speed control levers.
6 Check Fluid Levels ❏ Fill & check Engine oil level.
❏ Check transmission fluid level.
❏ Reduce & check tire pressures
(Front tires 40 psi, rear tires 15 psi).
7 Mower Assembly ❏ Torque mower blade bolts.
7 Lubrication ❏ Lubricate all grease & oil points.
8 SAFETY CHECKS ❏ Check for LOOSE HARDWARE.
❏ Check all OPERA
TOR CONTROLS.
❏ Test P
ARKING
BRAKE.
❏ Perform MO
WER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
❏ Perform SAFETY INTERLOCK SYSTEM CHECK
.
8 Burnish Electric Clutch ❏ Burnish electric clutch (run for 15 seconds, repeat 10 times) .
❏ Repeat MO
WER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)