Pre-StartCheckList
Make the following checks and perform the service required
before eachstart-up.
1. Checkthe guards, deflectors, grass bag,and covers to
make sure all are in placeand securelytightened.
2. Checkthe blade control (A, Figure 1) and wheel drive
control (B) to insure they work freely.
StartingandOperation
Engine and Blade
1. Pull the blade control (A, Figure 3) against the handle.
2. Start the mower:
Manual Start Models: Pullthe rope start handle (B)
to crank the engine.
Electric Start Models: Insertthe key(C) into the
ignition switch (D), located on the right side of the
handle abovethe rope guide. Turnthe keyto crank
the engine.
3. After the enginestarts, allow a brief warm-up until the
engine runs smooth before beginning mower operation.
NOTE:To stop the engine (and blade), releasethe blade
control.
Figure 1:Mower controls
3. Checkthe cutting height. Adjust to the desired height.
Refer to the Section 'Cutting Height Adjustment'.
4. Checkthe engineoil and add oil as neededto bring the
level up to the full mark (A, Figure 2). Referto the
Engine Owner'sManualfor oil specifications.
Figure2: Checkingengine oil
5. Add fuel to the tank after pushing the mower outside
wherefumes can safely dissipate. Fill thetank to 1-1/2
inches belowthe top of the filler neck (to allow for fuel
expansion). Makesure the cap is tightened after fueling.
Refer to the EngineOwners Manual for fuel
specifications.
6. Cleanthe exterior surfaces of the cutting deck and
engine of any accumulation of spilled fuel, dirt, grass,
oil, etc. Keepthe engine air intakescreen and cooling
fins clear at all times.
Figure3: Starting the mower
¢'D
m.
To Next Page
Loading...
Need help?
General
