Snapper SPV21675FC (7800265) - Troubleshooting

Troubleshooting
PROBLEM
EngineWill Not Start
Using Recoil Starter
EngineWill Not Start
(ElectricStart Models)
EngineStalls or Stops
After Running
Engine Loses Power
ExcessiveVibration
Mower Will Not Move
Loss Of Traction
Transmission Noise
Ground Speed
TooFast/ TooSlow;
Unableto Adjust
Ground Speed
Cutting Grass Improperly
Poor Grass Discharge
Oil Leaking
PROBABLECAUSE
1. Fueltank empty. 1.
2. Engineneeds priming. 2.
3. Spark plug wire disconnected. 3.
1. Fueltank empty. 1.
2. Engineneeds priming. 2.
3. Spark plug wire disconnected. 3.
CORRECTIVEACTION
Fillfuel tank with fresh fuel.
Prime. Check EngineManual for Instructions.
Placespark plug wire onto spark plug.
Fillfuel tank with fresh fuel.
Prime. Check EngineManual for Instructions.
Placespark plug wire onto spark plug.
4. Wiring harnessdisconnected. 4. Connectwiring harness.
5. Battery dead. 5. Chargeor replacebattery.
1. Bladecontrol is releasedor is not being held 1. Bladecontrol should be held securely against
securely against handle.
2. Fueltank empty.
3. Engineair pre-cleaner and or air cleanerdirty.
4. Spark plug defective or gap set improperly.
5. Water,debris or stale fuel in fuel system.
1. Engineair pre-cleaner or air cleanerdirty.
2. Spark plug faulty.
3. Water,debris or stale fuel in fuel system. 3.
1. Damaged,out of balanceor bent mower blade.1.
2. Loose blade components. 2.
3. Loose or missing air lift (if equipped). 3.
4. Lumpy or frayed belt. 4.
1. Build-up of debris on or around wheel drive 1.
components.
2. Transmission cableadjustment required. 2.
3. Drive belt requires replacement. 3.
4. Damagedtransmission. 4.
1. Transmission cableadjustment required. 1.
2. Damagedtransmission. 2.
1. Build-up of debris on or around wheel drive 1.
control components.
2. Transmission cableadjustment required. 2.
3. Drive belt requires replacement. 3.
4. Damagedtransmission. 4.
1. Cutting height too low or high. 1.
2. Forward speedtoo fast. 2.
3. Cutting bladedull or damaged. 3.
1. Forward speedtoo fast. 1.
2. Grassis wet. 2.
3. Excessivelyworn or damaged blade. 3.
4. Build up of grass clippings and debris under 4.
deck.
5. Improper blade installed on deck.
6. Bladeinstalled improperly on deck.
1. Leaking engine case.
handle at all times during operation of mower.
2. Fill with fuel to proper level.
3. Cleanfree of all debris.
4. Service spark plug.
5. Drain and cleanfuel system.
1. Cleanor replace filters.
2. Service spark plug.
Drainand cleanfuel system.
Service mower blade.
Service and tighten loose parts.
Replaceair lifts. Tighten to proper torque.
Replacebelt.
Cleandebris.
Adjust transmission cable.
Replacedrive belt.
Contactauthorized SNAPPERdealer.
Adjust transmission cable.
Contactauthorized SNAPPERdealer.
Cleandebris.
Adjust transmission cable.
Replacedrive belt.
Contactauthorized SNAPPERdealer.
Adjust cutting height.
Adjust to a slower speed.
Sharpen cutting edgesor replace blade.
Adjust to a slower speed.
Mow when grass is dry.
Service mower blade.
Cleandeck.
5. Install proper SNAPPERblade.
6. Install blade properly.
1. Contactauthorized SNAPPERdealer.
2. Checkand tighten drain plug.
3. Makesure dip stick or oil filler cap is securely in
)lace.
€1D
t_
m.
17