ASSEMBLING THE WHEELS (See Figure 3)
1. Remove the battery from the unit.
2. Insert the wheel assembly (1) into the support rod (2).
3. Align wheel assembly hole to desired position. Slide bolt (3) through hole and attach fastening knob (4) to bolt (3).
4. Tighten the fastening knob (4).
NOTE: The wheels are used to control the depth of operation. To adjust the height of the cultivator, move the bolt to a higher
or lower hole position. The wheels can be removed for greater tilling depth.
2
1
Fig. 3
4
3
ASSEMBLY
9
To Next Page
Loading...
