Snapper Z2002K User Manual

CHECKLIST BEFORE OPERATION
1. M ake sure fuel tank is full. Use regular unleaded gasoline (see engine owner's manual for more
details).
A warning A
HANDLE GASOLINE WITH CARE-IT IS HIGHLY FLAMMABLE.
DO NOT SMOKE. ENGINE SHOULD BE OFF AND COOL. USE
APPROVED GAS CONTAINER. NEVER FILL TANK INDOORS.
WIPE UP ANY SPILLS. REPLACE CAP TIGHTLY
2. Make sure dirt and foreign matter is kept out of gas tank. Use a clean funnel and gas can.
3. Do not mix oil with gasoline.
4. Do not use white, high test or premium gasoline. Do not use de-icers, carburetor cleaners, or other
such additives.
5. Check the crankcase oil level. Make sure the engine is off. The mower should be parked on a level
area. Do not overfill, (see your engine manual for more detailed instructions.)
6. Check the hydrostatic transmission oil level, (see "Maintenance" section of this manual.)
7. Check battery fluid level.
8. Inspect V-belts.
Check tire pressure:
Front tires Rear tires
Models Z1202B, Z1203B-
-10" 24 psi
18"
12 psi
Models Z1402K, Z1802K, Z2002K-
-13" 20 psi
20" 24 psi
Models Z1403K, Z1803K, Z2003K--
-13" 20 psi
20" 24 psi
Models Z1404K, Z1804K, Z2004K--
-13- 16 psi
20" 16 psi
10. Make sure underside of mower deck is free of grass.
11. Make sure mower blades are sharp and secured tightly.
12. Clean the air intake screen on the engine if necessary.
13. Perform any other maintenance as it becomes necessary.
(see the "Maintenance" section of this manual.)
IMPORTANT: Before cutting grass, clutch must be broken-in as follows: With engine at full RPM engage
deck until blades come to full speed and then disengage until blades come to a complete
stop. Repeat 10 times to seat clutch properly.
4

Snapper Z2002K Specifications

General

Brand	Snapper
Model	Z2002K
Category	Lawn Mower
Language	English