Extension / telephone number
You can add any extension or telephone number to the busy lamp field.
- You can start a call by pressing the respective busy lamp key. If an internal extension is
programmed, you can see whether that extension is currently busy:
If the LED next to the key flashes, the party receives a call.
If the LED is consistently lit, the party has answered a call and is currently busy.
If the LED next to the respective key flashes, you can take the call by pressing the respective
key next to the flashing LED.
Intercom
You can add any extension in the PBX system and then use this function key to directly
communicate with this extension through the intercom. The other party must have the intercom
activated on their device. Intercom refers to a conventional intercom system (similar to walkie-
talkies) directly connecting you to the other party’s speaker by pressing the assigned function key.
Additional functions via * codes
Entering various codes (as listed on the following page) allows you to additionally program functions
such as call transfer to the keys.To do so, simply enter the code with the desired number in the entry
field.
Functions via *-codes
Control codes allow direct access to the telephone system’s functions. The following codes apply:
Code Description
**## Restart devices, only for snom devices!
#+n
Use outside line "n" to call the telephone number ("n" replaces the “0” otherwise required
to access an outside line)
*1 Start and end voice recording (if this function is enabled for the extension)
*11+TN Permanent call forwarding to telephone number (TN)
**11 Cancel permanent call forwarding
*12+TN If not available, forward to telephone number (TN)
**12 Cancel call forwarding if no answer
*13+TN If busy, forward call to telephone number (TN)
**13 Cancel call forwarding if busy
*14+TN If not registered, forward to telephone number (TN)
**14 Cancel forward if unregistered
*2+Speed dial Directly dial the extension/telephone number via speed dial
To Next Page
Loading...
