Configuration File Parameter Guide 166 Back to Contents
M100 KLE Administrator and Provisioning Manual
“audio” Module: Audio Settings
The audio settings include jitter buffer parameters and RTP port settings.
All the audio settings are included in the general configuration file.
Setting:
audio.x.jitter_mode
Description: Select the desired mode for the jitter buffer: fixed (static) or adaptive. This
setting depends on your network environment and conditions.
Values: fixed, adaptive Default: adaptive
Setting:
audio.x.fixed_jitter.delay
Description: When in fixed jitter buffer mode, set the delay (in ms) desirable to provide
good audio quality with the minimal possible delay.
Values: 30–500 Default: 70
Setting:
audio.x.adaptive_jitter.min_delay
Description: When in adaptive jitter buffer mode, set the minimum delay (in ms)
desirable to maintain data packet capture and audio quality.
Values: 20–250 Default: 60
Setting:
audio.x.adaptive_jitter.target_delay
Description: When in adaptive jitter buffer mode, set the target delay (in ms) desirable
to provide good audio quality with the minimal possible delay.
Values: 20–500 Default: 80
Setting:
audio.x.adaptive_jitter.max_delay
Description: When in adaptive jitter buffer mode, set the maximum delay (in ms)
desirable to maintain data packet capture and audio quality.
Values: 180–500 Default: 240
Setting:
audio.x.rtp.port_start
Description: Sets the Local RTP port range start.
Values: 1–65535 Default: 18000
To Next Page
Loading...
