To Next PageTo Next PageWhat to do if ERROR and CAL MODE light are on after self test on Snorkel Lifting Systems?
If both the ERROR and CAL MODE lights are illuminated after the self-test on your Snorkel Lifting Systems, make sure to follow the proper calibration procedures.
What to do if I get a joystick and sensor calibration error on my Snorkel PRO 100?
If you're encountering joystick and sensor calibration errors with your Snorkel Lifting Systems, repeat the calibration procedure once.
How to fix a valve calibration error on Snorkel PRO 100?
If you are experiencing a valve calibration error with your Snorkel Lifting Systems, ensure that you are following the correct calibration procedure.
General| Brand | Snorkel |
|---|---|
| Model | PRO 100 |
| Category | Lifting Systems |
| Language | English |
Procedure for calibrating the joystick for lift and extend functions.
Procedure for calibrating the EMS system sensors.
Procedure for calibrating joystick for lift and extend on updated TB 120s.
Procedure for calibrating sensors on updated TB 120s.
Calibration step for boom angle software on specific TB 120 models.
Calibrating primary joystick and sensors for PRO 100/126 and TB 120 (post-Sep 1994).
Calibrating backup sensors for PRO 100/126 and TB 120 (post-Sep 1994).
Detailed steps for sensor calibration for PRO 100/126 and TB 120 (post-Sep 1994).
Troubleshooting primary EMS errors occurring after system power-up.
Troubleshooting primary EMS errors when joysticks are not deflected.
Troubleshooting primary EMS errors occurring during normal operation.
