22
ACCESSORIES
Drift Cutters
Drift cutters are optional accessories and may be
included with some models with pre-drilled holes
in the sides of the auger housing. Installation is
optional.
Drift cutters are used to help cut through snow
drifts that are higher than the auger housing and
allow the cut snow to fall into the auger housing.
Drift cutters are installed (one per side) on the
auger housing pointing up at a forward angle of
approximately 45 degrees. They are fastened
using 2 hex head (or carriage) screws, flat
washers and locknut knobs per side.
They may be installed in the opposite direction
for storage.
To Next Page
Loading...
