8
2. Securely install the supplied screw, washer
and hex nut.
Handle Assembly
1. Attach the lower handles using four (4) bolts.
Each side will require two (2) bolts.
2. Attached the upper handle to the lower handle
using four (4) knobs, washers and bolts.
NOTICE: Do not bend or kink the control cables.
The cables should be routed under the handle
assembly and not wrapped around the handle or
knobs. The cables must move freely and not bind.
3. Secure the speed control cables to the handle
with provided clips.
Note: Do not secure the auger or drive control
cables with the clips.
To Next Page
Loading...
