Page | 4
Step 3 Pump Install
Braided Line Kits Only- Install (2) 3/8” NPT to
4AN Straight fittings into the pump inlet and outlet
using E6000® sealant on the threads. Do not
overtighten as damage to the pump housing can
occur.
Quick Connect Kits Only-Remove the blue
rubber plugs from the quick-connect fittings by
first pushing the plug toward the pump, hold the
grey collar against the pump, and gently pull the
blue plug from the fitting. Warning: Pulling against
the quick connects with excessive force may
cause fitting damage.
Step 1: Position the fluid pump so that the inlet is
positioned at or below the lowest point of the
reservoir, and within two feet of the reservoir.
(Pump can be installed in any orientation). This
will ensure the pump is primed with fluid for
optimal flow and pressure to the nozzles.
**Arrows on the pump inlet and outlet indicate
the direction of fluid flow**
Step 2: Install the fluid pump with four (4) #8x1&1/2” screws and four (4) #8 washers (supplied) in
desired mounting location.
Step 3: Fit the high temp nylon tubing or braided line between the tank outlet fitting and the pump inlet,
ensuring there are no kinks in the line and there is no stress on the fittings. Sharp kinks/bends can
cause a leak in the system.
Braided Line Kits Only- Using the 2’ or 1’ stainless braided line section supplied in the kit connect the
tank outlet to pump inlet.
Quick Connect Kits Only- Once high temp nylon is measured from tank outlet to pump inlet cut tubing
using razor blade. Remove any burrs so that the fluid line properly seals against the internal o-rings
inside the quick connect fittings. Insert tubing into the quick connects until fully seated, and pull lightly
against quick connects to ensure proper installation between tank outlet to pump inlet
CAUTION: Pump must be shielded from road debris and direct tire wash. Failure to do so will
result in pump failure.
To Next Page
Loading...