Snow Performance Boost Cooler 210 - Step 4 Nozzle Selection

Page | 5
Step 4 Nozzle Selection
Hyper-Sonic® Nozzle Identification Chart:
Nozzle Number (Stamped On Side Of Nozzle)
Nozzle Size
1
60 ML/MIN
2
100 ML/MIN
3
175 ML/MIN
4
225 ML/MIN
5
375 ML/MIN
6
625 ML/MIN
Locate your Hyper-Sonic® water-methanol nozzles in the kit and compare the number stamped on the
side to the above chart to determine its size. Nozzle sizing is determined by horsepower (which
approximates the engine airflow) and boost (which approximates intake charge heat).
Determine your vehicle HP and boost/or no boost (N/A) and determine what size nozzle is needed for
your application using the nozzle selection chart below. If you are unsure what nozzle to run with your
given HP and boost send a email to tech@snowperformance.net for assistance.
Forced Induction
Nozzle Size
200-400 HP
#3 175 ML/MIN
400-600 HP
#5 375 ML/MIN
600-800 HP
#6 625 ML/MIN
Naturally Aspirated
Nozzle Size
200-350 HP
#1 60 ML/MIN
350-650 HP
#3 175 ML/MIN
650-850 HP
#5 375 ML/MIN
Seal the appropriate nozzle into the nozzle holder fitting using E6000® sealant on the nozzle threads.
**The end of the nozzle with the fine mesh screen should be inserted into the nozzle holder**
Correct Correct
**Teflon sealants are not compatible with methanol, and should not be used with the install of
your Snow Performance Boost Cooler®**