Page | 3
Step 2 Tank Install
OPTIONAL: If desired you can use the stock windshield washer fluid tank as the tank for your water-
meth system. Simply drill and tap a 3/8” NPT hole in desired feed spot for system and install the 3/8”
NPT fitting into the tank using E-6000 sealant on threads/around area.
BRAIDED LINE KITS ONLY: If OEM windshield washer fluid tank and 3qt tank do not want to be used
a upgrade exists to move your tank to the trunk of any vehicle (See Part# SNO-40012-BRD) and other
larger trunk mount tank options (See Part# SNO-40014-BRD)
Step 1: Install 3/8” NPT to ¼” Quick Connect fitting or 3/8” NPT to 4AN Elbow fitting into the bottom of
the reservoir using E6000® sealant on the threads.
Step 2: After allowing the thread sealant to dry, fill reservoir with water and check for leaks around tank
fitting and level sensor. If leak occurs use E6000® sealant.
Step 3: Install the 3qt. tank with four (4) #8x1&1/2” self-tapping screws and four (4) #8 washers
(supplied) in desired mounting location. Typical placement is any void area inside the engine bay.
The reservoir should be installed above the pump, but below the nozzle. This keeps
the pump primed and avoids fluid leaking into nozzle when not in use
CAUTION: To avoid gravity feeding of fluid with rear mount reservoirs, it is essential to use a
solenoid upgrade (Part # SNO-40060 / SNO-40060-BRD). Do not operate your rear mount reservoir
equipped vehicle without an anti-siphon solenoid installed.
To Next Page
Loading...