4
ENGLISH
INSTALLATION INSTRUCTIONS
OPEN THE TRUCK TAILGATE AND CLEAN TRUCK BED RAIL
BEFORE YOU INSTALL:
• We recommend using safety
glasses during installation.
• Keep truck tailgate down at all times
during assembly.
• Cap installation or removal requires
four people or use of a forklift.
• Read all instructions thoroughly
before installing cap.
INSTALLING CAP
(FOUR PEOPLE OR
FORKLIFT REQUIRED)
1. Clean bedrails, top of bulkhead, rear
truck window and front window of
cap with 50/50 isopropyl alcohol
and a clean cloth.
2. Remove all spacers from both sides
tucked into the bulb seal, located on
the under side of the cap sill, if still
present.
Spacer position, shown close-up, should be removed.
Remove (4) spacers tucked into the bulb seal, on the underside
of the cap sill.
Scan to See
Installation
Videos
To Next Page
Loading...