Snuza PICO 2 - Diaper Fitment and Placement

English
Page 9
Basic Pico Functions
The Movement Indicator Light ashes green on each movement.
If no movement is detected for 15 seconds, your Pico will vibrate to rouse
your baby. If no movement is detected for a further 5 seconds, your Pico
will sound an audible alarm.
Basic App Functions
The Snuza Connect App is designed to bring you information on your
baby’s breathing rate, body position, skin temperature, fall detection,
battery levels and alert you if the Pico’s clip is open. Customise your
warning settings to your preference in the App.
Warnings on the App can be dismissed by swiping them from left to
right. This excludes breathing rate and fall detection. These can only be
dismissed by pressing the power button on the device. Ensure that your
smartphone is connected to the app in order to receive all notications
and warnings.
. 6 DIAPER FITMENT AND PLACEMENT
Correct diaper tment is essential for the Pico to work. The thin ap of
material at the top of the diaper must be folded over the thicker part
before the diaper is closed (this is the section to which the Pico will be
attached). The diaper should t snugly on your baby with the top of the
diaper just below his/her belly button. Loose tting diapers will gape,
causing the monitor to lose contact with your baby's skin and false alarm.
A very ‘full’ or wet diaper may also cause it to gape. If your baby sleeps
on his or her side, the Pico should be placed to the left or right-hand side
of your baby's navel.
• The World Health Organisation recommends that babies sleep on their
backs. Place the Pico near the centre of your baby's tummy (1)
• If your baby prefers sleeping on his/her left side, attach your Pico to
either position 4 or 2.
• If your baby prefers sleeping on his/her right side, attach your Pico on
position 5 or 3.
• If your baby prefers sleeping on his/her tummy, attach your Pico close
to position 4 or 5.