Soca ST-320 - TROUBLESHOOTING; CARD SENSED BUT THE DOOR LOCK DOESNT WORK; SYSTEM PASSWORD IS ENTERED BUT CANNOT ENTER INTO VARIOUS FUNCTIONAL SELECTION OF THE SETTING MODE; HOW TO USE THE DURESS CODE SETTING

VII. TROUBLESHOOTING
1.
Card sensed but the
door lock doesn't
work.
Solution:
(1)
Please
check if the
power
supply is on the
proximity
reader and
the electric lock-
(2)
lf
(1)
is chaked,
please
check
the electric lock
power
supply and
whether the connecting
points
are correct.
(3)
Continuous
proximity.
Please remove the card
from
the
reader and
try again.
(4)
Please check
whether the
door opening mode
is
correct.
3. System
password
is entercd but cannot
enter into various
functional
selection
of the setting
mode.
Solution
: Incomplete
input of system
password, please
check
whether the following
format has
been entered:
*#XXXX#
(XXXX
represents
system
password),
or firet
press
"*"
then entervalid
system
password
+#XXXX#
4. How to use
the duress code
setting?
Solution
:
(1
)
Users
should change
door opening
mode to 4-digit
password
door opening(mode
code
l), or
proximity
card
or 4digit
password
door
opening(mode code
4) in order
to enable duress
code setting.
(2)After
the door
opening mode
is set
(please
refer
to
item 5
of the setting
mode functional
selection on how
to set door
opening mode),
press
"
*
#
The Duress code
+
4digits door
opening
password
#", then
the duress
alarm output
function will execute.
5.
How to temimte
antidamage actiEtkn
q
dutaa
&m tctivity?
Solution :
Enter into systsm setdng
modo or oDdr
fu dc.
6. What
is the operation
of the door sensor
detection
(red
switch)?
Solution
: lf the door
sensor detection
function
is being set at
ON
(for
detail,
refer to item
7 of the sefting
mode functional
selection
in the manual)
and if the
door is not
closed
within 30 seconds,
then the anti-damage
output function
will
be activated.
l5