118
The user may find the following booklet helpful: How to Identify and Resolve Radio-TV
Interference Problems, available from the U.S. Government Printing Office, Washington, D.C.
20402.
Canada Certification
The marking of “IC:2394A-CHS1” on the device means: “2394A-CHS1” is the certification
number, and the term “IC’ before the equipment certification number only signifies that
Industry Canada technical specifications were met.
Radio Frequency Interference Requirements – Canada
This Class B digital apparatus meets the requirements of the Canadian Interference-Causing
Equipment Regulations. Cet appareil numérique de la Classe B respecte toutes les exigencies
du Reglement sur le Matériel Brouilleur du Canada.
CE Marking & European Union Compliance
Products intended for sale within the European Union are marked with a CE Mark which
indicates compliance to applicable Directives and European Normes (EN), as follows.
Amendments to these Directives or ENs are included: Normes (EN), as follows:
Applicable Directives:
Radio and Telecommunications Terminal Equipment Directive 1999/5/EC
Low Voltage Directive 73/23/EEC
Applicable Standards:
EN 55 022 – Limits and Methods of Measurement of Radio Interference Characteristics of
Information Technology Equipment.
EN 50 082-1 – Electromagnetic Compatibility – General Immunity Standard, Part 1:
Residential, Commercial, Light Industry.
IEC 801.2 – Electromagnetic Compatibility for Industrial Process Measurement and Control
Equipment, Part 2: Electrostatic Discharge Requirements.
IEC 801.3 – Electromagnetic Compatibility for Industrial Process Measurement and Control
Equipment, Part 3: Radiated Electromagnetic Field Requirements.
IEC 801.4 - Electromagnetic Compatibility for Industrial Process Measurement and Control
Equipment, Part 4: Electrical Fast Transients Requirements
LASER DEVICE: The following statement is required to comply with US and international
regulations:
Caution: Use of controls, adjustments or performance of procedures other than
those specified herein may result in hazardous laser light exposure.
Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice
No. 50, dated June 24, 2007.
Complies with IEC60825-1:2001-08
Class 2 laser scanners use a low power, visible light diode. As with any very bright light
source, such as the sun, the user should avoid staring directly into the light beam.
Momentary exposure to a Class 2 laser is not known to be harmful.
To Next Page
Loading...
