18
1. Power on the CHS. Press and hold the small power button until the LED turns
blue and the CHS beeps twice (low-high).
The LED blinks blue once per second to show that the Bluetooth radio is on
but not connected.
2. Open the CHS-compatible application that you installed.
3. Enable Bluetooth on the Apple device. A Bluetooth device search will begin.
4. In the list of found devices, select Socket CHS. If prompted, tap Pair.
In the device search, the CHS will appear as Socket CHS[xxxxxx]. The
characters in brackets are the last six characters of the CHS Bluetooth Device
Address (BDA), which is labeled inside the battery compartment.
The CHS will beep once after it has connected and is ready to scan barcodes.
The LED will also blink blue once every 3 seconds.
To Next Page
Loading...
