Connect Device in Basic Mode
In this mode the scanner functions and communicates similar to a
keyboard. Therefore, the scanner will work with Notes, and any other
application that supports an active cursor.
1. Power on the scanner. Make sure the scanner is
discoverable (unpaired).
2. Go to Settings > Bluetooth.
3. Make sure the Bluetooth is “On” and scan for devices.
4. In the list of found devices, tap S730 [xxxxxx] to Pair.
5. The scanner will connect to the host device.
6. The scanner will beep once after it has connected.
*If you have trouble connecting or pairing with host device, turn host
device’s Bluetooh o/on, and/or perform factory reset on the scanner
(see page 47).
Now you are ready to scan barcodes!
14
To Next Page
Loading...
